Description
Removable Decals
This vinyl is removable, so you can put it anywhere you like. It won’t work on all painted surfaces simply because some paints have components that repel the adhesive. They won’t adhere to painted concrete sheeting (as sometimes found in old homes), or rough timber boards. You will know immediately as it won’t stick down.
With some type of card (like a credit card), smooth over your decal to ensure adhesion to the transfer paper (clear).
Making sure your surface is clean, gently remove the white backing paper from your decal.
If you are putting this on the fridge or car, make sure the surface is free of dust and dirt. You can also spray it with soapy water to slide the decal into place.
Iron On Fabric Transfers
If you are putting this decal on fabric, like a t-shirt – wash and dry fabric, iron where the decal is to go. You will need a hard surface to do this – a cutting board is good. Remove backing paper (clear baking paper) and then place your decal straight down on the fabric. Place a piece of baking paper over the decal and slowly move a hot iron over the surface for about 10-15 seconds.
Make sure there is no water in your iron and it is on the hot setting, not the steam setting.
Move over your decal a few times. Sometimes the decal starts out pink and it is done when it changes to a silver shimmer (if that’s the colour you ordered). Gently peel back the plastic (it may melt a little, this is ok) and remove altogether. From now on, wash fabric inside out and iron on reverse side.
In short
Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Baking Paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold
Wait at least 24 hours before washing