Rusted Lime

1. I’m not old I’m Vintage – 2 seater


These removable vinyl decals can be put on walls, cars, fridges, cupboards, and any other painted surface. Perfect for renters or the office, you can remove them when you need to without leaving any marks on the wall. Easy to apply, these decals will bring you considerable joy every time you look at them.

Bling up your clothes with some sparkle with Iron On decals. (not available in all designs)

Please be in touch for a custom quote by emailing

Available in several colours and each design is cut in A4 size or smaller.

Tutorial on how to use iron on and removable vinyl decals

Copyright Kate Rusted Lime 2019

SKU: N/A Categories: , Tags: ,


Removable Decals

This vinyl is removable, so you can put it anywhere you like. It won’t work on all painted surfaces simply because some paints have components that repel the adhesive. They won’t adhere to painted concrete sheeting (as sometimes found in old homes), or rough timber boards. You will know immediately as it won’t stick down.

With some type of card (like a credit card), smooth over your decal to ensure adhesion to the transfer paper (clear).

Making sure your surface is clean, gently remove the white backing paper from your decal.

If you are putting this on the fridge or car, make sure the surface is free of dust and dirt. You can also spray it with soapy water to slide the decal into place.

Iron On Fabric Transfers

If you are putting this decal on fabric, like a t-shirt – wash and dry fabric, iron where the decal is to go. You will need a hard surface to do this – a cutting board is good. Remove backing paper (clear baking paper) and then place your decal straight down on the fabric. Place a piece of baking paper over the decal and slowly move a hot iron over the surface for about 10-15 seconds.

Make sure there is no water in your iron and it is on the hot setting, not the steam setting.

Move over your decal a few times. Sometimes the decal starts out pink and it is done when it changes to a silver shimmer (if that’s the colour you ordered). Gently peel back the plastic (it may melt a little, this is ok) and remove altogether. From now on, wash fabric inside out and iron on reverse side.

In short
Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with Baking Paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold

Application Instructions (heat press)

• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold

Wait at least 24 hours before washing